Page 1 of 1

Help

Posted: Sun Nov 13, 2011 9:27 pm
by hayhay7789
I am setting up Mac OS 7.5.3 on Basilisk II. I have downloaded the .smi and .part files from Apple. The only issue is, in the guide I am following, I am supposed to open them. They are in disk image format. When I open them, my current OS (Mac OS X 10.6.8) says that the disk mounter "cannot mount the disks because the disks are not recognized."

What should I download to open these files?

Re: Help

Posted: Sun Nov 13, 2011 9:46 pm
by Ronald P. Regensburg
You are not supposed to open the 19 files in MacOSX.

Do you follow this guide? http://www.emaculation.com/doku.php/bas ... _osx_setup

Re: Help

Posted: Sun Nov 13, 2011 10:10 pm
by hayhay7789
Ronald P. Regensburg wrote:You are not supposed to open the 19 files in MacOSX.

Do you follow this guide? http://www.emaculation.com/doku.php/bas ... _osx_setup
Yeah, I use that guide. Thanks for informing me of this. I must have read the instructions improperly. Thank you again :mrgreen:

Re: Help

Posted: Sun Nov 13, 2011 10:12 pm
by Cat_7
The confusion might be around this part in the guide
Then download the 19 installer parts for System 7.5.3 from Apple and place them in the folder.
Take a look at the file names. If the first is named with a ”.smi” extension and the others with a ”.part” extension, you can skip the next step of double-clicking all files individually. Double-clicking the files will unpack them, leaving you with the double amount of files in the folder. When finished, remove the files not named with the ”.smi” or ”.part” extensions.
It means that when the files you downloaded already have the one .smi and 18 .part extensions, you do not need to open them in OSX. They can be used in basilisk directly lateron in the installation.

Best,
Cat_7

Re: Help

Posted: Sun Nov 13, 2011 10:15 pm
by hayhay7789
Okay. Thanks guys for your help. I'm really looking forward to System 7 on my MacBook. Just like my old Performa :mrgreen: