Hello,
I've tried Fusion on an old PC (486) with mdsos 6.22.
All was ok : rom, config, etc.
But when I launch fusion, nothing. Blak screen then white screen.
My bootdisk is ok (7.53), its functiun on a real mac. Memory OK. All OK.
I've also tried to create other hard disk with Hpv explorer. Nothing again.
I'v' also seen that Hpv explorer can't read "fusion.hfx" (hard disk created by Fusion).
Have I forgotten something in my configuration ?
Daniel
Microcode
Fusion on msdos : nothing
Moderators: Cat_7, Ronald P. Regensburg
-
- Expert User
- Posts: 868
- Joined: Sat Aug 30, 2003 4:15 pm
- Location: UK
- Contact:
Have you ran setup.exe and configured fusion properly?
Run that, the it to boot from a MacOS install disk and create a blank disk to install it to, then in the setup programme, select Launch Emulator and see what happens.
Also, make sure that your rom is compatible and set up properly and not corrupt, and if you are using a CD rom to install from, make sure you have the MS-DOS cdrom drivers (can't remember what they're called)
Hope that helps
If you still can't get it to work, then just reply and we'll try and give you some more help.
Stephen
Run that, the it to boot from a MacOS install disk and create a blank disk to install it to, then in the setup programme, select Launch Emulator and see what happens.
Also, make sure that your rom is compatible and set up properly and not corrupt, and if you are using a CD rom to install from, make sure you have the MS-DOS cdrom drivers (can't remember what they're called)
Hope that helps
If you still can't get it to work, then just reply and we'll try and give you some more help.
Stephen
Suite...
My rom is ok. Its functiuns with Basilik and vMac.
My config is OK and I've no CD reader on my 486 PC.
The first screen when I launch Fusion is a black screen with "-" who blinks (like a prompt). Then white screen. Something.
I've tried on a pc with Win95 an another with Win XP. On XP with Dosbox, no possibility .
I've tried many "Fusion" downloaded on different sites. Idem.
Daniel.
My config is OK and I've no CD reader on my 486 PC.
The first screen when I launch Fusion is a black screen with "-" who blinks (like a prompt). Then white screen. Something.
I've tried on a pc with Win95 an another with Win XP. On XP with Dosbox, no possibility .
I've tried many "Fusion" downloaded on different sites. Idem.
Daniel.
-
- Expert User
- Posts: 868
- Joined: Sat Aug 30, 2003 4:15 pm
- Location: UK
- Contact: