Emaculation.com

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
ubuntu [2018/03/10 23:33] – [Introduction] cat_7ubuntu [2018/03/11 01:37] – [Preparation] cat_7
Line 31: Line 31:
  
 We provide a pair of packages that were built on Ubuntu Intel/AMD 64 bit. Find them at our forum entry [[http://www.emaculation.com/forum/viewtopic.php?p=35420#35420|SheepShaver for Linux]].  There is a build that runs in full-screen (if you are experiencing bad mouse movement, check the forum notes).  And a build that runs in a window (the full-screen build crashes a lot when running in a window).  These builds are dated 03-09-2010. We provide a pair of packages that were built on Ubuntu Intel/AMD 64 bit. Find them at our forum entry [[http://www.emaculation.com/forum/viewtopic.php?p=35420#35420|SheepShaver for Linux]].  There is a build that runs in full-screen (if you are experiencing bad mouse movement, check the forum notes).  And a build that runs in a window (the full-screen build crashes a lot when running in a window).  These builds are dated 03-09-2010.
- 
-== Set memory access == 
-Due to a change in how programs in Linux are allowed to use memory, before using SheepShaver you need to set a variable in the file \\ 
-/etc/sysctl.conf \\ 
- 
-At the end of the file add this line: vm.mmap_min_addr = 0 
- 
-  Assuming you're using KDE, to edit sysctl.conf graphically just type: 
-  "kdesu kwrite /etc/sysctl.conf" into your run box (Alt + F2). 
- 
-  If you're using Gnome then: "gksu gedit /etc/sysctl.conf"