Page 1 of 1
Frameskip setting in ~/.sheepshaver_prefs set to 8 - why?
Posted: Thu Apr 11, 2019 8:00 pm
by AlexSantos
I don't see this documented anywhere but there is a line in the ~/.sheepshaver_prefs that reads "frameskip 8".
I set it to 0. Where is this documented?
Re: Frameskip setting in ~/.sheepshaver_prefs set to 8 - why
Posted: Thu Apr 11, 2019 8:08 pm
by Ronald P. Regensburg
It shouldn't read 8. If you set the Refresh Rate in preferences settings to Dynamic, as instructed in the setup manual, it will read 0.
(frameskip 8 sets the refresh rate to 7.5 Hz, which will make the software cursor very jumpy.)
Re: Frameskip setting in ~/.sheepshaver_prefs set to 8 - why
Posted: Thu Apr 11, 2019 8:51 pm
by AlexSantos
Thank you. I am much obliged.