Page 1 of 1
Running OSX After install
Posted: Mon Feb 18, 2019 2:43 pm
by victornguyen
How do you actually run the OS after it installs? This sounds like a dumb question but it is puzzling me. I installed it fine but I don't know how to make it run after install.
Re: Running OSX After install
Posted: Tue Feb 19, 2019 12:17 am
by adespoton
Remove the install CD from the list of volumes and the disk image should just boot when you fire up PearPC.
Re: Running OSX After install
Posted: Tue Feb 19, 2019 3:01 pm
by ClockWise
You can also just select to boot from the disk rather than the cdrom when presented with the choice.
I mentioned this at the beginning of the guide, but I will update it to put that important information at the end, as well. Thanks for the heads up.