TRIED EVERY NET SOLUTION FOR 10.3.4 NO LUCK

willvg · Post by **willvg** » Fri May 28, 2004 3:30 am

Ok ive tried just about everything from removing the net card from my config, changing the net card to 3com, bridging conncection, reinstalling drivers
but os x always shows the same thing

IS THERE ANYWAY TO REMOVE THE HARDWARE IN OSX COMPLETELY SO IT CAN REDETECT IT

MDZ61384 · Post by **MDZ61384** » Fri May 28, 2004 3:43 am

not sure if this is the way to go, but click the dropdown box and delete the realtec thing you have right there

make sure you use the pearpc build from here http://www.kelley.ca/pearpc/

boot up and try again. it should redetect...at least it did fo rme

willvg · Post by **willvg** » Fri May 28, 2004 3:46 am

it wont let me delete it (delete is greyed out)

MDZ61384 · Post by **MDZ61384** » Fri May 28, 2004 3:47 am

try that build of pearpc anyway and see if it lets you autoconfigure it again?

willvg · Post by **willvg** » Fri May 28, 2004 3:49 am

just installed the latest build booting up osx now

willvg · Post by **willvg** » Fri May 28, 2004 3:52 am

still doesnt work

Cybermagellan · Post by **Cybermagellan** » Fri May 28, 2004 3:58 am

If you change the location from Automatic to Manuall and enter the correct info does it turn the card green...?

MDZ61384 · Post by **MDZ61384** » Fri May 28, 2004 4:05 am

have you tried bridging connections? I did that...click connection you are connected to, ctrl + click the TAP-32/OpenVPN connection, right click and bridge them. worked for me anyways...then I just connected normally through dhcp with my pearpc/mac

willvg · Post by **willvg** » Fri May 28, 2004 2:07 pm

if i bridge the conncections can i still have the ip set to auto
or since they r bridged do i manually have to set it

willvg · Post by **willvg** » Fri May 28, 2004 3:51 pm

still nothing