PearPC Control Panel returns always error
Posted: Wed Jul 06, 2016 11:23 am
Hi!
First time I tried to use PearPC and tried to create config file.
I set all to make emulated computer correctly and when I try to save config it reports error:
Run-time error '52': Bad file name or number
It was looking like incorrect name or unsupported characters - I tried to crate name in all possible ways also tried old MS-DOS 8.3 file name, nothing helps. Even if I get unclearly saved CFG file and try import, always the same error.
When I try to call PearPC from command line with that CFG file it starts but in few seconds closes with error report.
Can anybody explain me where I do mistake?
Used files:
PearPC Control Panel - standard 1.0
pearpc-0.5-win32-jitc.zip
Thank you all.
Miro
First time I tried to use PearPC and tried to create config file.
I set all to make emulated computer correctly and when I try to save config it reports error:
Run-time error '52': Bad file name or number
It was looking like incorrect name or unsupported characters - I tried to crate name in all possible ways also tried old MS-DOS 8.3 file name, nothing helps. Even if I get unclearly saved CFG file and try import, always the same error.
When I try to call PearPC from command line with that CFG file it starts but in few seconds closes with error report.
Can anybody explain me where I do mistake?
Used files:
PearPC Control Panel - standard 1.0
pearpc-0.5-win32-jitc.zip
Thank you all.
Miro