Switch to full style
About PearPC, a PPC Mac emulator for Windows and Linux, and to a limited extent MacOSX, that can run MacOSX up to 10.4.
Post a reply

How to setup Network in PearPC (Mac OS X Tiger)?

Thu Feb 16, 2017 10:25 am

Hi!

So I got working 10.4 in PearPC. I transfer files by TransMac. Works Fine,no problems.
But I want network on it. Any chances to configure network connection on PPC?
Im using WiFi. And my network card is Atheros AR5005G.

Here is a screenshot for proof :wink:

Image

Re: How to setup Network in PearPC (Mac OS X Tiger)?

Thu Feb 16, 2017 6:22 pm

There's a thread in here where we tried to get the OpenVPN tunnel solution working with the OS X build of PearPC. I wasn't able to do it; I also wasn't able to get the Windows version of PearPC to do it inside a wrapper under OS X. But if you can figure it out, it's using Tun/Tap networking via an OpenVPN setup on Windows, and something similar would be needed on OS X.

From http://emaculation.com/doku.php/pearpc there's a link to the now-defunct pearpc site that supposedly had a document for how to set it up under XP at some point.

Does anyone have a copy of that documentation? We could probably put it up on the wiki.

Re: How to setup Network in PearPC (Mac OS X Tiger)?

Thu Feb 16, 2017 7:27 pm

Courtesy of archive.org: http://web.archive.org/web/201307040221 ... r_XP/Vista

Re: How to setup Network in PearPC (Mac OS X Tiger)?

Thu Feb 16, 2017 7:30 pm

Odd; when I looked that up, I didn't get any content.

Re: How to setup Network in PearPC (Mac OS X Tiger)?

Thu Feb 16, 2017 8:17 pm

At first I didn't either. The captures from March 2016 and newer show an HTTP 302 error. The July 2013 and earlier captures, however, do show the original content of the page.

Re: How to setup Network in PearPC (Mac OS X Tiger)?

Fri Feb 17, 2017 8:45 am

Have updated the wiki to point to that archive. Thanks for the link.
Post a reply