Hello fellow Emaculators
I set up Basilisk II to run OS 7.5.3 on my G4 Powerbook, which runs OS X 10.5.8. The emulator was working just fine, until I tinkered with the virtual memory settings. I've since read on these forums that doing that is a no-no, so at least I understand what caused my installation of Basilisk to crash.
The thing is I simply can't get Basilisk o run since then. I've trashed the old installation and downloaded a fresh one. I've attempted to boot using exactly the same (Proforma) ROM as worked previously, but all I get every time is a Sad Mac icon and a spinning wheel of death. I've reset my computer's PRAM & NVRAM and verified the hard disk, but to no avail.
Also, I'm running OS 9 on Sheepshaver simultaneously with no problems, if that's of any significance.
I'd be very grateful for any advice and help. Many thanks in antcipation.
Basilisk II won't recognise ROM or run after crash
Moderators: Cat_7, Ronald P. Regensburg
-
- Forum All-Star
- Posts: 1706
- Joined: Tue Oct 14, 2008 12:12 am
Re: Basilisk II won't recognise ROM or run after crash
As I think you will have predicted, that worked perfectly first time.
Thank you so much for taking the time to attend to my issue - I really appreciate it. And thanks also for helping to maintain this site and for putting so much time and effort into it. I'm only just discovering the many joys of emulation. Its a great pleasure, and it's a real boon to have such a friendly, helpful and knowledgeable person as yourself to refer to about it.
Thanks again.
Best wishes
Glenn
Thank you so much for taking the time to attend to my issue - I really appreciate it. And thanks also for helping to maintain this site and for putting so much time and effort into it. I'm only just discovering the many joys of emulation. Its a great pleasure, and it's a real boon to have such a friendly, helpful and knowledgeable person as yourself to refer to about it.
Thanks again.
Best wishes
Glenn