E-Maculation
https://www.emaculation.com/forum/

Building Basilisk II in MinGW under Windows
https://www.emaculation.com/forum/viewtopic.php?f=6&t=9238
Page 1 of 1

Author:  emendelson [ Sat Mar 04, 2017 11:58 pm ]
Post subject:  Building Basilisk II in MinGW under Windows

Following the excellent guide, I was able to set up MinGW and Msys and build SDL, but I'm having trouble with Basilisk II. When I try to ./configure, I get this error message:

checking whether VirtualProtect works... no
configure: error: Sorry, Windows VM functions don't work as expected on your system.

Is that possibly because I'm doing this under 64-bit Windows 10? Or is there an easy fix?

And is it necessary (under Windows) to build BII before building SheepShaver (which is my actual goal here)?

Author:  darthnvader [ Sun Mar 05, 2017 4:18 am ]
Post subject:  Re: Building Basilisk II in MinGW under Windows

emendelson wrote:
Following the excellent guide, I was able to set up MinGW and Msys and build SDL, but I'm having trouble with Basilisk II. When I try to ./configure, I get this error message:

checking whether VirtualProtect works... no
configure: error: Sorry, Windows VM functions don't work as expected on your system.

Is that possibly because I'm doing this under 64-bit Windows 10? Or is there an easy fix?

And is it necessary (under Windows) to build BII before building SheepShaver (which is my actual goal here)?


I don't think you need to build BII to build SS, but I think SS uses the slirp code from the BII source DIR.

Author:  emendelson [ Sun Mar 05, 2017 1:34 pm ]
Post subject:  Re: Building Basilisk II in MinGW under Windows

Thank you for that. Unfortunately, I'm getting the same error message when building SS under 32-bit Windows 7, so any advice on building in MinGW would be welcome. (Maybe the best advice is "Try it under Cygwin"?)

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/